MBM29LV001BC
MBM29LV001BC is 1M (128K x 8) BIT FLASH MEMORY manufactured by Fujitsu Semiconductor Limited.
FEATURES
- Single 3.0 V read, program, and erase Minimizes system level power requirements
- patible with JEDEC-standard mands Uses same software mands as E2PROMs
- patible with JEDEC-standard world-wide pinouts 32-pin TSOP(I) (Package suffix: PFTN
- Normal Bend Type, PFTR
- Reversed Bend Type) 32-pin PLCC (Package suffix: PD)
- Minimum 100,000 program/erase cycles
- High performance 55 ns maximum access time
- Sector erase architecture One 8K byte, two 4K bytes, and seven 16K bytes Any bination of sectors can be concurrently erased. Also supports full chip erase
- Boot Code Sector Architecture T = Top sector B = Bottom sector
- Embedded Erase TM Algorithms Automatically pre-programs and erases the chip or any sector
- Embedded Program TM Algorithms Automatically writes and verifies data at specified address
- Data Polling and Toggle Bit feature for detection of program or erase cycle pletion
- Hardware RESET pin Resets internal state machine to the read mode
- Automatic sleep mode When addresses remain stable, automatically switch themselves to low power mode
- Low VCC write inhibit ≤ 2.5 V
- Erase Suspend/Resume Suspends the erase operation to allow a read data in another sector within the same device
- Sector protection Hardware method disables any bination of sectors from program or erase operations
- Sector Protection Set function by Extended sector protection mand
- Temporary sector unprotection Temporary sector unprotection via the RESET pin
Embedded Erase TM and Embedded Program TM are trademarks of Advanced Micro Devices, Inc.
MBM29LV001TC-55/-70/MBM29LV001BC-55/-70 s PACKAGE
32-pin plastic TSOP (I) 32-pin plastic TSOP (I)
(FPT-32P-M24)
Marking Side (FPT-32P-M25)
32-pin plastic QFJ (PLCC) Marking Side
(LCC-32P-M02)
MBM29LV001TC-55/-70/MBM29LV001BC-55/-70 s GENERAL DESCRIPTION
The MBM29LV001TC/BC are a 1M-bit, 3.0 V-only Flash memory organized as 128K bytes of 8 bits each. The MBM29LV001TC/BC are offered in a 32-pin TSOP(I) and 32-pin PLCC packages....